Circulation pump for central heating, hot water electronic IBO-BETA2 25/40/180 lifting 4 m

The electronic circulation pump for central heating IBO-BETA 25/40 (BETA 2) is designed to force the circulation of water in central heating and domestic hot water systems. It can also be used in solar heating systems, for air conditioning and circulating refrigeration systems.

Along with the pump, the customer receives gaskets for unions (2 pieces), a Polish instruction manual for the pump and a warranty card.

The pump should be installed on a straight section of pipe between two shut-off valves, in a place accessible for venting, inspection or service. The pump should be installed so that the pump axis is horizontal. Before starting the installation of the pump, it is absolutely necessary to read the instruction manual.

The main areas of application of electronic IBO pumps

The pump is used in central heating systems, including underfloor heating, domestic hot water and drinking water.

Circulation pumps are used in installations with constant or slightly variable flow, i.e.:

heating installations
heating installations

Technical parameters of the energy-saving IBO pump

power supply: 230 V / 50 Hz
lifting height of the water column: up to 4 meters
max. capacity: 50 l/min
mounting standard: 180 mm
connection on the pump, external thread: 1 1/2 in
connection for installation on a flare: 1 in
ambient temperature: max 40OC
liquid temperature: from 2 OC to 110 OC
power consumption: from 5 W to 22 W - energy-saving
the set with the pump includes gaskets, unions and a power cord with a plug for connection

Special features and advantages of IBO-BETA pumps:

energy efficient
very high quality
meets the requirements for energy class A pumps
certainty and reliability of operation
ease of assembly
silent operation: up to 38 dB (A)
high quality
no maintenance required
built-in short-circuit protection

Available operating modes:

AU: mode of automatic selection of pump parameters to the needs of the installation

Operating modes recommended for underfloor heating:

CP1: constant pressure operation - high setting
CP2: constant pressure operation - low setting

Operating modes recommended for central heating installation:

PP1: operation according to the characteristics of alternating pressure - high setting
PP2: variable pressure operation - low setting

night mode:

after the built-in temperature sensor detects a decrease in temperature by 0.1 degrees C/min in about 2 hours - it will switch to the economical night mode.
if the temperature increases by about 10 degrees C - the pump will automatically return to normal operation

Manual mode:

I,II,III - manual mode to set three pump speeds.

Construction - hydraulic part:

glandless centrifugal pump
threaded cast iron body
composite pump impeller

Construction - engine:

asynchronous 2 pole
ceramic shaft and radial bearings
carbon thrust bearing
insulation class: I
voltage: 230/240V
three-stage speed regulation
degree of protection: IP 44

The pump is equipped with a permanent magnet motor and a differential pressure controller that automatically and continuously adjusts the pump capacity to meet the actual needs of the system.

The pump control panel is located on top of the motor for ease of use by the user. Its dial shows the current electricity consumption.